Volume 41,   Issue 3                             March 2006


News & Regulations

IGMA Accepts New Gas Fill Test Method

The Insulating Glass Manufacturers Alliance (IGMA) has announced that the “Spark Emission Spectrography,” a recently-coined generic term for the GasGlass® instrument manufactured by Sparklike of Helsinki, Finland, will be accepted as a viable method for determining initial gas fill concentration for the IGMA Certification Program, effective immediately. 

IGMA conducted the first data correlation study between gas fill measurements taken by the gas chromatograph method and the GasGlass device in 2002. The results of this study indicated that measurements taken with the GasGlass device were comparable to those taken with a gas chromatograph. Based on this research encompassing 200 gas-filled insulating glass units, the IGMA GasGlass Best Practices Working Group was formed in January 2003 to expand the initial correlation data. 

The working group developed a standardized operating protocol for the device, forming the foundation to develop an ASTM standard (currently under development), developed a second round robin series of testing to establish correlation between different GasGlass devices and is presently working on a position paper for the GasGlass device. 

“This device provides another methodology for approved certification testing laboratories to verify initial gas fill and is truly a non-destructive verification process unlike the gas chromatograph or the oxygen analyzer,” said Margaret Webb, IGMA executive director. “This will remove the requirement for manufacturers to use septum plugs so that the units tested for initial gas fill can undergo cycling without compromising the insulating glass unit seal.” 

Webb continued, saying, “IGMA is continuously researching new methods that will offer alternatives not just to certification, but also to the insulating glass manufacturing process itself.”

Correction

One of the measures in the Big Book of Lists in the February 2006 issue was incorrectly identified. The line “Square footage produced” should have read “Square footage facilities/glass produced.” USGlass regrets the error. 


USG
© Copyright 2006 Key Communications Inc. All rights reserved. No reproduction of any type without expressed written permission.